Rear Door

2





1 The holes marked (1) should be sealed with sealing cap P/N 9170187-0.

2 The holes marked (2) should be filed square. Use plastic nut P/N 9132846-8 as a template.

3 The holes marked (3) should be filed square. Use clip P/N 3511468-5 as a template.

4 Center punch where marked (4). Drill a square 9 x 9 mm (3/8' x 3/8") hole for box nut P/N 946947-9.

5 Where marked (5) replace rubber plug to grommet P/N 1259852-0.