Test Mode 2

Test Mode 2

Test mode 2 is used to see if there are signals from the speedometer and solar sensor.

Note! Some preparation is necessary to modify signals to test mode 2.







Shield the solar sensor (cover it over).

For test of the speedometer signal, jack car up so wheels can turn freely.

Warning! Chock rear wheels and set hand brake.

The equivalent road speed needs to be at least 5 mph (10 km/h) before the control module can detect the signal.

- Ignition on.
- Press button twice (for about 1 second each time).

The LED should start flashing rapidly once test mode 2 is activated.

The control unit now checks to see if the signals from the speedometer and solar sensor are correct. There are two acknowledgement codes which can follow.

If display responds with code 1-1-2:

- Signal from solar sensor is correct.

If display responds with code 1-1-3:

- Signal from speedometer is correct.

If the solar sensor is activated at the same time, the solar sensor acknowledgement code will appear first (1-1-2) followed by the road speed signal acknowledgement code (1-1-3); the control unit will continue to flash these codes until the ignition is switched off.

If neither acknowledgement code is received, the LED will continue to flash rapidly.

If LED does not light up when pressing button, perform fault tracing for communication with the control module.

To exit from test mode 2:

Switch ignition off to exit test mode 2 once checks have been made.