Air Mix Control Motor

14 - Ventilation damper motor (14)
15 - Floor/defroster damper motor (15)
16 - Driver's side temperature damper motor (16)
17 - Passenger side temperature damper motor (17)
18 - Recirculation damper motor (18)






1. Ignition off
Damper motors are fitted on climate control unit, two on the left and three on the right hand side.
2. Expose damper motor:
- Remove soundproofing.
- Remove glove compartment (on passenger side). Refer to "Blower Motor Replacement". Service and Repair
3. Undo connector:
- Disconnect connector from damper motor.
- Hold catches in on both sides and pull straight out.
4. Remove damper motor:
- Undo the screws (3) holding the damper motor.
- Remove damper motor from damper shaft.

NOTE: Ventilation damper motors have a geared segment fitted to the output shaft, with a matching geared segment on the damper shaft. See Image.

- To replace recirculation damper motor, see "Evaporator Core Replacement". Service and Repair
5. Install:
- Damper motor (3 screws).
- Connector.
- Sound insulation.
- Glove compartment (on passenger side).
- Carry out self-adjustment of damper motor limit positions. For more information refer to "Fault Tracing Diagnostic System, On-board Diagnostic Unit and Test Modes". [1][2]Initial Inspection and Diagnostic Overview