Drilling Hole to Access Clip Hole Side Molding (Front Door)

Protect:





- the drill chuck with a piece fuel hose (A).

- the paint by installing a piece plastic hose (B) on the drill bit.

Drill a guide hole 3 mm (1/8") through the clip side molding rear hole on the front door.





Install a panel between door inner and outer panels to protect the door outer panel.

Make a hole 16 mm (5/8") with hole saw.

File down any burrs.

After-treatment

Prime modified surfaces according to Service Manual:

TP 8102201
Section 8(80)
Paintwork repairs
850 1995-
section C1