Programing Functions

Programing Mode





To change or check the control module programing, the alarm must first be set to programing mode. Then alarm should be deactivated.

Open the driver's door.





Ignition on.






Press the function button and hold it down.
Status LED 2 will light after approx. 3 seconds.





Hold the button down.
Shut door.





Release the function button.
The alarm can now be programed.





Programing





Programing can be interrupted at any time by opening the door. The alarm then reverts to standard mode. Indicator LEDs I, II and III display the selected function and programed value.

Use the function button to advance to the function to be changed.





Indicator LEDs I, II and III light up or indicate as per the function table below.

Function Table





Ignition off. Status LED 1 should light up





The alternative/signal pattern set is displayed as a combination of lit and unlit indicator LEDs as per the table below. To change the setting, advance to the required setting using the function button.





Programing Table





Signal Pattern Diagram





Save The New Setting





Press remote control button
When status LED 1 starts flashing the new value has been saved.

If further functions are to be changed: Ignition on.




First, advance to the tunction to be changed.





When Completely Finished





Open door.
The alarm will then revert to standard mode.
Inform the customer of current programing and note any new settings in the customer's owner's manual.