Seat Occupied Recognition Assembly Overview

Seat Occupied Recognition Assembly Overview

The passenger occupant detection system service kit is precalibrated and must not be disconnected. The service kit consists of:

• Seat Occupied Recognition Control Module (J706)

• Seat Occupied Recognition Pressure Sensor (G452)

• Passive Occupant Detection System Mat

• Seat cushion

Observe safety precautions when working on seat occupied recognition. Refer to => [ Passive Occupant Detection System Safety Precautions ] Service Precautions.

• The passenger occupant detection system is only installed in the front passenger side.






1 Seat Occupied Recognition Pressure Sensor (G452)

• Is a component with the seat occupied recognition mat

• Removing and Installing, refer to => [ Passive Occupant Detection System ] Passive Occupant Detection System

• The connector may be disconnected for removing and installing

2 Seat pan

3 Retaining clip

4 Cushion

• For seat pan

• Do not separate from the seat occupied recognition mat - 6 -

5 Retaining clip

• Do not release

6 Mat

• For seat occupied recognition

• Is a component with the seat occupied recognition pressure sensor (G452)

• Do not separate from the seat pan upholstery - 4 -

• Removing and Installing, refer to => [ Passive Occupant Detection System ] Passive Occupant Detection System

7 Mount

• For Seat Occupied Recognition Control Module (J706)

8 Spreader pin

• For securing the mount to the seat pan

9 Electrical wiring harness

• Do not separate from the seat occupied recognition pressure sensor (G452) and seat occupied recognition control module (J706)

10 Passenger seat position sensor (G554)

• Is a component of the electrical wiring harness - 9 -

• Removing and Installing, refer to => [ Seat Position Sensor ] Seat Position Sensor

11 Seat Occupied Recognition Control Module (J706)

• Removing and Installing, refer to => [ Passive Occupant Detection System ] Passive Occupant Detection System

• Do not disconnect the electrical connector.