Knee Airbag

Knee Airbag

• The knee airbag is installed above the pedal cluster.

Removing

Read the Safety Instructions for working with airbags, belt tensioners and battery cut-out units. Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units General Safety Precautions ] Airbag, Belt Tensioner and Battery Cut-Out Units General Safety Precautions.

- Switch the ignition on.

- Disconnect the vehicle battery.

- Remove the side instrument panel cover on the driver side. Refer to => [ Side Instrument Panel Covers ] Side Instrument Panel Covers.

- Remove the left instrument panel trim on the driver side. Refer to => [ Driver Side Left Instrument Panel Trim ] Driver Side Left Instrument Panel Trim.

- Remove the driver footwell cover. Refer to => [ Footwell Covers ] Footwell Covers.

- Remove the right instrument panel trim on the driver side. Refer to => [ Front Passenger Side Right Instrument Panel Trim ] Front Passenger Side Right Instrument Panel Trim.

- Unscrew the 2 nuts - 1 - (6 Nm).

- Unscrew the nuts - 2 - and - 3 - (6 Nm).

• The nuts - 2 - and - 3 - are installed in the direction of travel at the front at the knee airbag.

- Remove the knee airbag - 4 - from the bracket - 5 -.

Electrostatic discharges can lead to unintended deployment of the airbag. Therefore, the technician must discharge static electricity from the body before disconnecting the ignition and ground wiring. This is done, for example, by briefly touching the vehicle body or the door striker pin.

- Disconnect the harness connector from the knee airbag.

• The harness connector is at the front on the tunnel side in the direction of travel.






Installation

- Installation is performed in the reverse order of removal.

Make sure that the airbag connector engages audibly!

- Switch the ignition on.

Make sure that no persons are in the vehicle.

- Connect the vehicle battery.