Rear Lid Tail Lamps with LEDs

Rear Lid Tail Lamps with LEDs

Removing

- Turn off the ignition and all electrical consumers and remove the key.

- Open the rear lid.

- Unclip the service cover - 1 - from the rear lid trim.






- Unclip the cover - 1 - carefully to the side and out of the tail lamp assembly.






- Disconnect the connector - 1 -.






- Remove both nuts - arrows - and remove the tail lamp assembly - 2 - through the opening in the rear lid.

Installing

Install in reverse order of removal. Note the following:

- Align the tail lamp housing so that the gap is even all the way around the rear lid and then tighten the nuts to the tightening specification given in => [ Rear Lid Tail Lamps With LEDs Overview ] Rear Lid Tail Lamps With LEDs Overview.