Rear Lid Tail Lamps

Rear Lid Tail Lamps

Removal

- Turn off the ignition and all electric consumers and remove the key.

- Open rear lid.

- Unclip service cover - 1 - from rear lid trim.






- Carefully remove the cover - 1 - for the rear lid from the tail lamp assembly.






- Disconnect the connector - 1 -.






- Remove both nuts - arrows - and the tail lamp assembly from the opening in the rear lid.

Installation

Install in reverse order of removal. Note the following:

- Install the tail lamp assembly so that the gap between it and the rear lid is equal, then tighten the nut to 3 Nm.