Instrument Cluster

Instrument Cluster

Special tools, testers and auxiliary items required

• Release Lever (T10039)

• Wedge (T10039/1)

Removal

• It is not necessary to remove the steering wheel. To improve clarity, the steering wheel is not shown in the following illustrations.

• If the instrument panel insert is to be replaced, refer to => [ Instrument Cluster, Replacing ] Instrument Cluster, Replacing.

- Using the electrical or mechanical adjustment mechanism, fully extend and lower the steering wheel all the way.

- Turn off the ignition and all electric consumers and remove the key.

- Remove the trim strip on the driver side.

- Remove both screws - 2 - and the instrument cluster trim piece - 1 -.






• The cloth cover on the instrument cluster trim piece and be unclipped from the upper trim on the steering column.

- Starting at the top, pull the instrument cluster - 1 - out.






- Disconnect the connectors - 1 - and - 2 - and remove the instrument cluster.






Installation

Install in reverse order of removal, noting the following:

- Connect the connectors, insert the instrument cluster into the opening and lock both tabs at the top.

- Tighten the screws for the instrument cluster trim to 1.5 Nm.

- After installing, test the functions of the instrument cluster.