Lock Carrier

Lock Carrier with Attachments

Removing

• The lock carrier is a safety-relevant component and for this reason it may not be serviced.

• If damaged, replace the lock carrier.

• Information regarding the distance regulation control modules - 5 -.






Perform the following:

- Set the service position.

- Disconnect any harness connectors.

- Drain the coolant and disconnect the coolant lines.

- Disconnect the condenser lines.

- Together with a second technician, remove the guide pins (T10093) on the left and right longitudinal members - 2 - and remove the lock carrier with attachments - 1 -.

To disconnect the lock carrier - 1 - from the crossmember - 4 -, unscrew the bolts - 3 -.

Do not start the engine whenever the A/C system or coolant lines are disconnected.

• Never hang the condenser and the hydraulic fluid cooler on the lines.

• Never bend the condenser lines or the hydraulic fluid lines.

Installation






Perform the following:

If the lock carrier - 1 - was detached from the crossmember - 4 -, the bolts must first be tightened.

- Screw tightening specification - 3 -: 20 Nm.

- Attach the lock carrier - 1 - to the longitudinal members - 2 -.

- Install the left and right guide rods (3411).

- Move the lock carrier out of its service position. Refer to => [ Service Position, Resetting ] Service Position, Resetting.

Install in reverse order of removal.

• Make sure that all plug and hose connections are installed correctly during assembly.

• Information regarding the distance regulation control modules - 5 -.

- Align the lock carrier at the longitudinal members and between the fenders.