Front Wheel Housing Liner

Front Wheel Housing Liner

Removing

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1783)






• The following describes removing and installing the left wheel housing liner. Removing and installing the right wheel housing liner is identical.

• Due to equipment variations, small deviations must be considered during removal and installation.






Perform the following:

- Loosen the radar cover near the bumper.

- Remove the screws - 2 - and hex nuts - 5 -.

- Remove the front and rear wheel housing liners - 1 and 3 - from the fender.

Installation

• Check the expanding nuts - 4 - for damage and replace if necessary.






Perform the following:

- Install the front and rear wheel housing liners - 1 and 3 - in the fender.

- Install the hex nuts - 5 - and bolts - 2 - and tighten in the specified order. Refer to => [ Front Wheel Housing Liner Bolt Tightening Sequence ] Front Wheel Housing Liner Bolt Tightening Sequence.

- Tightening specification for hex nuts - 5 -: 2.5 Nm.

- Tightening specification for bolts - 2 -: 2 Nm.