Rear Door Limiter: Service and Repair

Door Strap






Perform the following:

Removing

- Remove subframe. Refer to => [ Subframe ] Subframe.

- Remove the bolt - 4 - from the B-pillar.

- Remove the bolts - 3 - and door strap - 1 -.

Installation

• Pay attention to the marked installation position - arrow -.

- Install the door strap - 1 - through the opening in the speaker.

- The seal - 2 - must be properly installed.

- Tighten the bolts - 3 -, tightening specification: 9 Nm.

- Tighten the bolt - 2 -, tightening specification: 30 Nm.