Rear Bumper Cover Assembly Overview

Rear Bumper Cover Assembly Overview

• Due to model variations, small deviations must be considered during removal and installation.






1 Rear Bumper Cover

• PP/EPDM material

2 Bolt

• 2 pieces per side

• Tightening specification: 3 Nm

• Under the tail lamps

3 Clip

• 1 pieces per side

• Under the tail lamps

4 Side guide

• Left and right

5 Wheel cover

• Is locked and bolted to the bumper cover

6 Lane change assistance control module 2 (J770) (Side Assist)

• Right

• Information regarding the lane change assistance

7 Bolt

• 1 pieces per side

• Tightening specification: 3 Nm

• Bolted to the lateral guide

8 Bolt

• 2 pieces per side

• Tightening specification: 3 Nm

• Attached to the wheel housing liner

9 Bolt

• Quantity: 6

• Tightening specification: 3 Nm

• Bolted to the brackets

10 Bolt

• 1 pieces per side

• Tightening specification: 3 Nm

• Bolted to the wheel covers

11 Lane change assistance control module (J769) (Side Assist)

• Left

• Information regarding the lane change assistance