Driveshaft with Triple Roller Joint AAR3300i Overview

Driveshaft with Triple Roller Joint AAR3300i Overview






1 Outer CV Joint

• Replace only as complete unit.

• Removing => [ Removing The Outer CV Joint ] Driveshaft with Triple Roller Joint AAR3300i

• Installing: Drive onto shaft using plastic hammer until compressed circlip seats.

• Checking, refer to => [ Outer CV Joint, Checking ] Outer CV Joint, Checking

2 Bolt

• There are different versions.

• Allocation, refer to the Parts Catalog

• There are 2 types of twelve-point bolts, with and without ribs. Distinguishing characteristic => [ Differences between a twelve-point bolt with ribs and a twelve-point bolt without ribs ]

• When installing a twelve-point bolt, always check what type of twelve-point bolt is to be used.

• Use the correct tightening specification for the specific bolt.

• The tightening specification for a twelve-point bolt with ribs is 70 Nm + 90°. For loosening and tightening specifications, refer to => [ Twelve-Point Bolt with Ribs, Loosening and Tightening, Driveshaft Threaded Connection ] Twelve-Point Bolt with Ribs, Loosening and Tightening, Driveshaft Threaded Connection.

• The tightening specification for a twelve-point bolt without ribs is 200 Nm + 180°. For loosening and tightening specifications, refer to => [ Twelve-Point Bolt with Ribs, Loosening and Tightening, Driveshaft Threaded Connection ] Twelve-Point Bolt with Ribs, Loosening and Tightening, Driveshaft Threaded Connection.

• Always replace if removed.

3 Locking Ring

• Always replace if removed.

• Insert in shaft groove

4 Thrust Ring

• Installed position => [ Installed location: spring washer and thrust washer on outer joint ] Driveshaft with Triple Roller Joint AAR3300i

5 Plate Spring

• Installed position => [ Installed location: spring washer and thrust washer on outer joint ] Driveshaft with Triple Roller Joint AAR3300i

6 Clamp

• Always replace if removed.

• Tensioning => [ Tightening Hose Clamp On Outer Joint ] Front Suspension

7 CV Boot

• Check for tears and scuffing

• Material: Hytrel (Polyelastomer)

8 Clamp

• Always replace if removed.

• Tensioning => [ Tensioning Clamp On Small Diameter ] Front Suspension

9 Driveshaft

10 Clamp

• Always replace if removed.

• Tensioning => [ Tensioning Clamp On Small Diameter ] Front Suspension

11 CV Boot for Triple Roller Joint

• Check for tears and scuffing

12 Clamp

• Always replace if removed.

• Tensioning => [ Tightening Hose Clamp On Outer Joint ] Front Suspension

13 Triple Roller Star with Rollers

The chamfer - arrow - points to drive axle splines.

14 Locking Ring

• Always replace if removed.

• Insert in shaft groove

15 Joint

16 Locking Ring

• Always replace if removed.

Differences between a twelve-point bolt with ribs and a twelve-point bolt without ribs





The contact surfaces - arrow A - and - arrow B - are different on the two-point bolts.

I Twelve-Point Bolt with Ribs - arrow A -
II Twelve-Point Bolt without Ribs - arrow B -