Turn Signal Bulb

Turn Signal Bulb

• The following illustrations show the removing and installing of the left rear turn signal lamp (M6) inside the tail lamp in the side panel on the left side. Removing and installing the rear right turn signal lamp (M8) inside the tail lamp in the side panel on the right side is identical.

Removing

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Remove the side panel tail lamps. Refer to => [ Tail Lamps ] Tail Lamps.

- Remove the 4 screws - arrows - and then remove the bulb holder - 1 - from the tail lamp.






- Push the turn signal bulb - 2 - into the bulb socket, turn it in - direction of arrow - and remove it from the bulb holder.






Turn Signal Bulb: 12V, 21W

Installing

Install in reverse order of removal. Note the following:

- Tighten the mounting bolts to the tightening specification given in the overview. Refer to=> [ Tail Lamps in Side Panel Overview ] Tail Lamps in Side Panel Overview.