Cap

Cap

Special tools, testers and auxiliary items required

• Assembly tool (T10389)






Removing

• The following describes removing and installing the right cap only. Removing and installing the left cap is identical.

- Guide the hook (T10389) (3438) 110 mm - dimension A - into the door and behind the locking bracket.






- Pull the locking bracket - 1 - to the rear 5 mm - arrow a -.

- Slightly pull the door handle - 3 - from the outer door panel - arrow b -.

- Remove the cap - 2 - from the door handle mounting bracket at a right angle- arrow c -.

• The door handle touches the outer door panel.

Installation

- Gently remove the door handle - 3 - slightly from the outer door panel - arrow c -.






- Place the cap - 2 - at a right angle onto the door handle mounting bracket.

- Guide the hook (T10389) 100 mm - dimension A - into the door up to the locking hooks.

• While installing, the cap is pressed into the outer door panel.

- Push the locking hook forward approximately 5 mm - arrow b -.

Install in reverse order of removal.

• Then, always perform a function test with door opened.