Pedal Cluster Overview

Pedal Cluster Overview






1 Bulkhead

• With studs for the mounting bracket.

2 Gasket

• Always replace

• Between the mounting bracket and the bulkhead.

• With self-adhesive.

• Installed on the mounting bracket.

3 Mounting Bracket

• For the clutch pedal.

• Removing and installing, refer to => [ Mounting Bracket ] Mounting Bracket.

4 Bolt

5 Over-Center Spring

• Removing and installing, refer to => [ Over-Center Spring ] Over-Center Spring.

6 Bushing

7 Pin

8 Clutch Pedal

• Removing and installing, refer to => [ Clutch Pedal ] Clutch Pedal.

9 Mount

• To remove and install, disconnect the clutch master cylinder from the clutch pedal. Refer to => [ Clutch Pedal ] Clutch Pedal.

10 Gasket

• Always replace.

• Between the clutch master cylinder and the mounting bracket.

11 Clutch Master Cylinder

• Remove and install after removing the mounting bracket. Refer to => [ Clutch Master Cylinder ] Service and Repair.

12 Clutch Position Sensor (G476)

• Removing and installing, refer to => [ Clutch Position Sensor G476 ] Service and Repair.

• Can be checked in "Guided Fault Finding" using the vehicle diagnostic tester.

13 Clip

• The clip must be removed in order to remove/install the hose/line assembly.

14 Supply Hose

• To the brake fluid reservoir.

• Plastic, with additional seals. Refer to => [ Plastic Supply Hose ] Removal and Replacement.

15 Nut

• 25 Nm

• Always replace.

• Self-locking.

• Quantity: 3

• For the mounting bracket to the bulkhead.

16 Nut

• 25 Nm

• Always replace.

• Self-locking.

17 Jounce Bumper

• For the clutch pedal.