Shift Solenoid: Service and Repair

Wiring Harness, Solenoid Valves

Removing

- Remove the valve body. Refer to => [ Valve Body ] Service and Repair.

- Disconnect the solenoid valve harness connector - 2 - from the transmission connector.






- Remove the bolt from the 14 pin transmission connector.

- Remove the connector and the wiring harness from the transmission housing.

Installing

Install in the reverse order of removal. Note the following:

- Replace the O-ring on the connector.

- Push the connector with a new O-ring all the way into the transmission.

- Tighten the bolt for the 14 pin transmission connector. For the correct tightening specification, refer to => [ Fastener Tightening Specifications ] Fastener Tightening Specifications.

- Install the valve body. Refer to => [ Valve Body ] Service and Repair.