Input Shaft Overview

Input Shaft Overview

• Heat the gears to approximately 100 °C (212 °F) using the inductive heat unit (VAS 6414) or equivalent. Wear protective gloves.

• Install all input shaft bearings using transmission fluid.

• Always replace the grooved ball bearing - item 4 -.






1 Lock Ring

• For the grooved ball bearing - item 4 -.

• Removing and installing, refer to => [ Transmission ] Transmission.

2 Transmission Housing

3 Lock Ring

• Select when replacing the grooved ball bearing - item 4 - and the input shaft - item 6 -. Refer to => [ Selecting the lock ring ] Input Shaft.

4 Grooved Ball Bearing

• Always replace.

• Removing, refer to => [ Removing the grooved ball bearing ] Input Shaft.

• Installed position, refer to => [ Grooved ball bearing installed position ] Input Shaft.

• Installing, refer to => [ Installing the grooved ball bearing ] Input Shaft.

5 5th Gear

• Available as a replacement part together with the input shaft.

• Removing, refer to => [ Removing the 5th gear ] Input Shaft.

• Installed position: The surrounding groove - arrow - faces the grooved ball bearing - item 4 -.

• Installing, refer to => [ Heat the 5th gear and install it. ] Input Shaft.

6 Input Shaft

• With the 3rd, 4th and 6th gears.

7 Cylindrical Roller Bearing

• With a lock ring.

• Removing, refer to => [ Removing the cylindrical roller bearing from the clutch housing ] Input Shaft.

• Installing, refer to => [ Pressing the cylindrical roller bearing into clutch housing. ] Input Shaft.

• Installed position: The lock ring inside the bearing faces the input shaft.

8 Clutch Housing