Front Three-Point Seat Belt Assembly Overview
Front Three-Point Seat Belt Assembly Overview
Vehicles without Belt End Fitting
1 Bolt
• Tightening specification 40 Nm
2 Belt height adjustment
3 Belt guide ring
4 Belt guide
• Locked in the B-pillar
• Slide all the way in
5 Automatic belt retractor
• Installed in the B-pillar
6 Belt anchor
• Pay attention to the tab/position when installing
7 Bolt
• Tightening specification 40 Nm
• Micro-encapsulated, replace after each loosening
8 Bolt
• Tightening specification 40 Nm
9 Belt latch
• Removing and Installing, refer to => [ Front Belt Latch ] Front Belt Latch
Vehicles with Belt End Fitting
Seat belt with belt end fitting Phase 1, replacement part from April 10, 2011 until December 16, 2011
1 Bolt
• Tightening specification 40 Nm
2 Belt height adjustment
3 Belt guide ring
4 Belt guide
• Locked in the B-pillar
5 Automatic belt retractor
• Installed in the B-pillar
6 Bolt
• Tightening specification 40 Nm
• Micro-encapsulated, replace after each loosening
7 Belt end fitting, phase 1
• With Quickfix-coupling rod
• Is able to be disconnected from the seat belt, not intended for customer use
• Replace the entire seat belt only in case of damage
8 Bolt
• Belt end fitting attachments
• When reusing, coat the bolts with locking fluid (D 154 000 A1) or with locking fluid (D 154 100 A1) and install them
• Tightening specification 40 Nm
9 Bolt
• Tightening specification 8 Nm
10 Belt latch
• Removing and Installing, refer to => [ Front Belt Latch ] Front Belt Latch
Seat belt with belt end fitting, phase 2, replacement part after December 16, 2011
1 Bolt
• Tightening specification 40 Nm
2 Belt height adjustment
3 Belt guide ring
4 Belt guide
• Locked in the B-pillar
• Slide all the way in
5 Automatic belt retractor
• Installed in the B-pillar
• Removing and Installing, refer to => [ Seat Belts ] Seat Belts
6 Bolt
• Tightening specification 40 Nm
• Micro-encapsulated, replace after each loosening
7 Belt end fitting, phase 2
• With sewn seat belt
• Not detachable
• In case of damage, replace the entire seat belt
8 Bolt
• Micro-encapsulated, replace after each loosening
• Tightening specification 40 Nm
9 Bolt
• Tightening specification 8 Nm
10 Belt latch
• Removing and Installing, refer to => [ Front Belt Latch ] Front Belt Latch