Model Name Badge Dimensions

Model Name Badge Dimensions

Assembly Information

• Heat the name plates or emblem before removing using hot air blower (V.A.G 1416).

• Use only adhesive remover (D 002 000 10) to remove any remaining adhesive when removing a name badge or emblem.

• Remove any adhesive residue left by the tape using adhesive remover (VAS 6349).

• Make sure the adhesive surfaces are free of dust and grease.

• Install the name badges or brand emblem immediately after cleaning.

• Only remove the protective film right before assembly.

• The temperature must be approximately 70 °F (21 °C).

• It is not possible to remove the name plates or emblem without damaging them.

• Follow the instructions for installing the name badges.






1 Name badge

• Brand name

• Follow the installation instructions.

2 Rear bumper cover

3 Side dimension

• 6 +/- 0.5 mm, from the outer edge of the rear lid to the name badge

4 Height dimension

• 45 +/- 1 mm, from the name badge to the tail lamp assembly

5 Tail lamp

6 Rear lid