Front Treble Speaker

Front Treble Speaker

Special tools, testers and auxiliary items required

• Wedges (T10383)

The left front treble speaker (R20) / right front treble speaker (R22) are installed inside the instrument panel.

• The following illustrations and procedures describe removing and installing the left front treble speaker.

• Removing and installing the right front treble speaker is identical.






1 Left Front Treble Speaker (R20)

2 Instrument Panel Cover

3 Instrument Panel

Removing

- Turn off the ignition and all electrical consumers and remove the key.

• From December 2011, there is a new installation procedure. It is no longer necessary to remove the instrument panel. Only the cover needs to be removed.

- Remove the instrument panel in order to gain access to the left front treble speaker connector.






• Pull the cover - 1 - carefully under the sunlight photo sensor (G107) when removing.

- Pry the cover - 1 - outward on the left and right sides using (T10383) - arrows -.

- Remove the cover - 1 - from the instrument panel - 2 -.

- Remove the bolts - 1 -.






- Disconnect the connector.

- Remove the treble speaker.

Installing

Install in reverse order of removal. Note the following:

- Tighten the left front treble speaker bolts to the tightening specification (2 Nm).

- Insert the clips on the cover into the mounts on the instrument panel, if necessary.

• Position the centering drift - 2 - in the center.

• Insert the pin into the clip.






- Push the cover - 1 - under the sunlight photo sensor.

- Attach the cover - 1 - from the inside to the outside.