Battery, Transmitter and Receiver Unit, Fuse and Wiring Harness, Overview

Battery, Transmitter and Receiver Unit, Fuse and Wiring Harness, Overview






1 Positive Connection

• Red wire with suitable connection

2 To Terminal 15a

• Connection to terminal 15a.

• Ensure wire is protected by fuse

• Fuse: maximum 15 A

3 Antenna Ground

• Make sure the ground is connected to the body properly

• Antenna location must be treated with suitable corrosion protection

4 Transmitting/Receiving Antenna

• Installed locations refer to => [ Transmitted Output, Antenna Installation Locations ] Transmitted Output, Antenna Installation Locations.

5 Shielded Antenna Wire

• Wire with coaxial connector

6 Telephone Or Two-Way Radio Transmitter/Receiver Unit

7 Wiring Harness

• Voltage supply positive via red wire, 2.5 mm2 cross section

• Voltage supply negative via brown wire, 2.5 mm2 cross section

• If necessary, wire to terminal 15a via black wire 1.5 mm 2 cross section

8 Fuse Holder

• Attach next to the battery (A)

9 To the starter (B)

10 Battery (A)

11 Negative Wire

12 Body Ground