Passenger Door Window Regulator Switch (E107)

Passenger Door Window Regulator Switch (E107)

Special tools, testers and auxiliary items required

• Trim Removal Wedge (VAS 3409)


• Turn off the ignition and all electrical consumers.

• Remove the key.

• When removing and installing components in visible area (switches, covers, trim, etc.), cover by taping the areas at which a prying tool ( (VAS 3409) , screwdriver) will be positioned using commercially available adhesive tape.

• The Push Button Illumination (L76) is integrated in the Passenger Door Window Regulator Switch and cannot be replaced separately.

Removing

- Remove the handle trim at the tabs - arrows - - 1 - using (VAS 3409) from the pull handle - 2 -.






- Disconnect the connector - 2 -.






- Open the four tabs - arrows - and remove the front passenger door window regulator switch - 2 - from the handle trim - 1 -.






Installing

Install in reverse order of removal. Note the following:

- Make sure the tabs click into place when installing.