Front Door Window Motor: Service and Repair

Window Regulator Motor

• Installation and removal only for the window regulator motor on the right side. Removal and installation of the window regulator motor on the left side should be carried out in the same manner.

Removing






- Removing front door trim panel.

- Secure the door window with adhesive tape to prevent it from falling down.


• Turn off the ignition and all electrical equipment.

• Remove the key.

- Disconnect the connector - 2 -.

- Remove three bolts - 3 -.

- Remove the window regulator motor and control module - 1 - from the mounts on the cable reel.

Installation


It is necessary to code the additional functions and pinch protection each time a new window regulator motor (door control module) is installed.






- Install the window regulator motor - 1 - in the cable reel mounts. Move the door window gently up and down so that the splines mesh between the motor and cable reel.

- Install the three bolts - 3 -.

Tightening specification - 3 -: 4 Nm

- Connect the connector - 2 -.

- Code the new window regulator motor using the Vehicle Diagnosis, Testing and Information System (VAS 5051B).

- For more information regarding the one-touch up/one-touch down and the pinch protection features.

Install in reverse order of removal.