Multi-Plate Clutch, Preparing for Installation

Multi-Plate Clutch, Preparing for Installation

Multi-plate clutch as a replacement part






1 Multi-Plate Clutch

• The cover on a new clutch is secured with a circlip.

2 Circlips

• Quantity: 10

• The circlips are of varying thicknesses. They are staggered in 0.1 mm increments.

• Refer to the notes regarding this in => [ Clutch, Installing and Adjusting ] Clutch, Installing and Adjusting.

3 Cover (End Cover)

• Ensure the inner sealing lip is not damaged, refer to => [ Clutch Cover, Installing ] Clutch Cover, Installing. A bushing is inserted by the manufacturer to protect the sealing lips. Leave this bushing in the cover.

4 Circlip

• For the cover.

- Press on the clutch cover while removing the clutch.






This prevents the clutch cover and the clutch disc carrier from sliding out of the clutch disc.

- Make sure the four seals fit correctly.






The ends of the seals should not overlap one another.

- Turn the seals one time. They must move freely and must not stick.

Important! Clutch cover location





- Look for a mark on the clutch - arrow -.

- Make a colored mark if there is no mark present. The cover tab should realign with this marked position later.

Set the clutch down in such a way that cannot fall over.

The clutch is now ready to be installed. Refer to => [ Clutch, Installing and Adjusting ] Clutch, Installing and Adjusting.