Passenger Occupant Detection System Control Module

Passenger Occupant Detection System Control Module

Removing

- Install the fixture for seat repair (VAS 6136) on the engine/transmission holder (VAS 6095).

Vehicles with seat height adjustment

- Bring seat to the uppermost position.

All vehicles

- Remove the front seat => [ Front Seat ] Front Seat.

- Secure the seat on the fixture for seat repair (VAS 6136).

- Disconnect the connectors - 4 - and - 5 - from the passenger occupant detection system control module (J706) - 1 -.

- Remove the bolt - 2 - (1,5 Nm).

- Remove the passenger occupant detection system control module (J706) - 1 - from the bracket - 3 - in - direction of arrow -.






Installation

- Install in reverse order of removal.

• It is necessary to perform a basic setting/coding in "Guided Fault Finding" using the Vehicle Diagnosis, Testing and Information System (VAS 5051B) if the passenger occupant detection system control module (J706) was replaced. Refer to => [ Airbag Components, Adapting ] Testing and Inspection.