Round Connector Systems

Round Connector Systems

Housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts, refer to => [ Secondary Lock ] Secondary Lock.

- Guide the release tool which fits the terminal housing into release channel on terminal housing.






- Grasp contact at wire and push it gently into terminal housing - arrow -.

• By pushing contact in direction of terminal housing, contact retaining tabs are lifted off the housing shoulder and can be released using the release tool.

- At the same time, push release tool in direction of terminal housing - arrow - and pull the released contact out of terminal housing.






- After removing the contact, release tool can be pulled out of terminal housing again.