Heated Oxygen Sensor, 6-Pin Universal

Heated Oxygen Sensor, 6-Pin Universal

• Use the faulty sensor as a guide for installing all of the accompanying attachments, cable ties or marking bands.

• Do not crimp or cut the wires otherwise the functionality of the heated oxygen sensor (HO2S) will be diminished.

Procedure

- Remove the old heated oxygen sensor.

- Lay both of the oxygen sensor next to each other so the sensor housings are the same level.






- Tie the excess length of the sensor (approximately 50 to 250 mm) (2 to 9 in.) back so it is the same length as the faulty sensor and secure it with cable ties - 1 -.






- Install the new heated oxygen sensor in the vehicle.