Tire Pressure Sensor: Service and Repair

Tire Pressure Sensor

Removing

- Remove the union nut - 1 -.






- Remove the tire pressure sensor - 2 - from rim well.

Installing


Clean the valve opening before installing the tire pressure sensor.

- Install the tire pressure sensor - 2 - with a new seal and washer. Install the tire pressure sensor into the marked positions - arrows - on the rim.






- Press the tire pressure sensor - 2 - on the spots marked with the - arrows - into the disc wheel (rim).

Install the union nut - 1 - on the tire pressure sensor.

- Install the tire pressure sensor - 1 - on the marked positions - arrows - in the rim and tighten the union nut to 8 Nm.







• Tighten the union nut only to the tightening specification.

• Sealing washer - 2 - becomes slightly deformed when doing this.

• The sealing washer can be installed one time only. At every installation, replace the sealing washer and rubber seal.

• Do not tighten the union nut again. This will damage the seal and it will leak.

Tightening Specification