High-Mounted Brake Lamp Bulb

High-Mounted Brake Lamp Bulb


• Turn off the ignition and all electrical consumers.

• Remove the key.

If one of the LEDs in the high-mounted brake lamp (M25) is faulty:

• The individual LEDs in the high-mounted brake lamp are in groups of four and supplied electricity as a group.

• The high-mounted brake lamp is designed in such a way that it still meets legal requirements when one LED group fails.

• If another LED group fails, these legal requirements are no longer met.

• When one LED group fails, the intact LEDs are given a higher load, by which failure of other LED groups can be assumed in the near future.

• Replace the high-mounted brake lamp if more than four separate LEDs have burned out in the high-mounted brake lamp.

Removing

- Remove the lower cover on the rear shelf.

- Disconnect the connector - 1 -.






- Remove the screws - 3 - and remove the high-mounted brake lamp.

Installing

Install in reverse order of removal, noting the following:

- Tighten the screws to 2 Nm.