Headlamp Switch: Service and Repair

Light Switch (E1)


• Turn off the ignition and all electrical consumers.

• Remove the key.

• When removing and installing components in visible area (switches, covers, trim, etc.), cover by taping the areas at which a prying tool ( Trim Removal Wedge (VAS 3409) , screwdriver) will be positioned using commercially available adhesive tape.

The Light Switch consists of:

• Fog Lamp Switch (E7)

• Rear Fog Lamp Switch (E18)

• Headlamp Switch Illumination Bulb (L9)

Removing

Check the light switch (E1) using the (Vehicle diagnostic tester) before removing it. Refer to => [ Light Switch (E1), Checking ] Testing and Inspection.

- Turn the light switch to 0.

- Push the light switch handle in - arrow 1 - and turn it a little to the right - arrow 2 -.

- Hold the rotary handle in this position and remove the light switch from the instrument panel by the handle - arrow 3 -.






- Disconnect the connector - arrow -.






Installing

- Connect electrical connector.

- Hold light switch firmly and press in rotary handle of light switch - arrow 1 - and turn slightly toward right - arrow 2 -.






- Hold the rotary handle in this position and insert the light switch into the instrument panel - arrow 3 -.

- Turn the rotary switch to the 0 position, release it and engage the light switch.