Oil Pressure Sender: Service and Repair

Oil Filter, Oil Cooler and Oil Pressure Switch Overview






1 Accessory Bracket

• Removing and installing, refer to => [ Accessory Bracket ] Service and Repair.

2 Oil Pressure Switch (F1)

• 20 Nm

• 1.4 bar - black

• Checking, refer to => [ Oil Pressure and Switch, Checking ] Testing and Inspection.

• Remove using the socket 24 mm and jointed extension (T40175).

3 Gasket

• Always replace.

4 O-ring

• No replacement part, part of the valve unit.

5 O-ring

• No replacement part, part of the valve unit.

6 Valve Unit

• With the O-rings.

7 Oil Filter Element

• 22 Nm

• See the notes in => [ If metal shavings or a large quantity of small metal particles are found when repairing an engine, this could indicate that the crankshaft or connecting rod bearings are damaged. To prevent further damage, perform the following steps after the repair: ] Oil Pan and Oil Pump.

• Removing and installing, refer to Maintenance Procedures.

• Remove and install using the oil filter wrench (3417).

8 Bolt

• 15 Nm

9 Connection

10 Seal

• Always replace

11 Oil Cooler

• See the notes in => [ If metal shavings or a large quantity of small metal particles are found when repairing an engine, this could indicate that the crankshaft or connecting rod bearings are damaged. To prevent further damage, perform the following steps after the repair: ] Oil Pan and Oil Pump.

• Ensure sufficient clearance to surrounding components.

• Removing and installing, refer to => [ Oil Cooler ] Oil Cooler.

• Coolant hose connection diagram. Refer to one of the following:

• With a manual transmission, refer to => [ Coolant Hose Connection Diagram ] [1][2]Cooling System

• With a Direct Shift Gearbox (DSG), refer to => [ Coolant Hose Connection Diagram ] [1][2]Cooling System

12 Gasket

• Always replace.

13 Bolt

• Tightening sequence and specification. Refer to => [ Accessory Bracket Bolt Tightening Sequence and Specification ] Ribbed Belt Overview.