Engine Mount Adjustment, Checking

Engine Mount Adjustment, Checking

• There must be at least 10 to 13 mm clearance - a - between the engine mount bracket - 2 - and the right longitudinal member.






• The casting edge on the engine mount bracket - 2 - must be parallel to the engine mount support arm - 1 -; dimension - x - must be the same at the front and the rear.

• Dimension - a - can also be checked with corresponding round stock.

Only if there is noise (the engine or transmission hitting the longitudinal member when driving around curves) and dimension - a - is not within 10 to 13 mm:

- Adjust the engine/transmission mount; refer to one of the following:

• Jetta/GLI for MY 08 through 10, Jetta SportWagen (US)/Jetta Wagon (Canada) for MY 09. Refer to => [ Engine and Transmission Mount, Adjusting ] Engine and Transmission Mount, Adjusting.

• GLI from MY 12. Refer to => [ Engine and Transmission Mount, Adjusting ] Engine and Transmission Mount, Adjusting.