Vacuum Sensor (G608)

Vacuum Sensor (G608)

Only on vehicles with a hydraulic brake booster

Removing

- Release and disconnect the connector from the vacuum sensor.

- Remove the vacuum hose and the vacuum sensor - 1 - from the brake booster.






Installing

- Install in reverse order of removal. Note the following:

- Install the vacuum sensor and the rubber seal in the brake booster.

- Make sure the rubber seal fits securely.

Remove the vacuum sensor from the vacuum line.

- Release clips with pliers - 1 -.






- Carefully pry the vacuum sensor - 2 - downward.

Assembling

- Assembly is performed in the reverse order of removal. Note the following:

- Attach the vacuum sensor carefully to the vacuum line.