Access/Start System Antenna In Rear Bumper (R136)

Access/Start System Antenna In Rear Bumper (R136)

The access/start authorization antenna in rear bumper is located behind bumper cover at rear.

• No coding, basic setting or adaptation is necessary if Access/start system antenna in rear bumper is replaced. Erase the resulting entry in the DTC memory using the Vehicle diagnostic tester.


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removing

- Remove the rear bumper cover.

- Press the detents outward - arrows - and pull the access/start system antenna in rear bumper - 1 - out of the bracket, while paying attention to the wires that are still connected.






- Disconnect the connector - 2 - and remove the access/start system antenna in rear bumper - 1 -.

Installing

Install in reverse order of removal.