Upper B-Pillar Trim

Upper B-Pillar Trim

Removing

• Removing and installing on the left side of the vehicle is described here. Removing and installing on the right side is identical.

- Remove the airbag emblem - 1 - and the screw - 3 - (4 Nm).

- Remove the clips - 4 - in the trim - 1 - from body in direction of - arrow -.

- Loosen the trim from the door seal molding.

- Remove the trim - 1 - from the upper mount.






- Remove the bolt - 1 - (40 Nm).

- Guide the belt end fitting with the seat belt - 2 - through the opening in the trim.






Installation

• Check all the fasteners for damage and replace if necessary.

• When installed, the seat belt height adjuster and button in the trim must be in the same position.

• The airbag emblem - 1 - must be replaced.

• Make sure the trim panel is installed inside the door seal.

- Install in reverse order of removal.