Lower B-Pillar Trim

Lower B-Pillar Trim

• Removing and installing on the left side of the vehicle is described here. Removing and installing on the right side is identical.

Removing

- Turn off the ignition if the vehicle has interior monitoring.

- Remove the sill panel strip. Refer to => [ Sill Panel Trim ] Service and Repair.

- Loosen the B-pillar upper trim. Refer to => [ Upper B-Pillar Trim, Loosening and Fastening ] Upper B-Pillar Trim, Loosening and Fastening.

- Remove the clips - 1 - and - 2 - in the trim - 3 - from the body.

- Loosen the trim - 3 - from the door seal molding.

- If the vehicle has interior monitoring, disconnect the wiring harness from the passenger compartment monitoring switch (E183).






Installation

- Install in reverse order of removal.

• Check all the fasteners for damage and replace if necessary.

• Make sure the trim panel is installed inside the door seal.