Driver Side Instrument Panel Cover

Driver Side Instrument Panel Cover

Removing

• For reasons of clarity, the steering wheel is not depicted in the illustration, it is not necessary to remove it.

- Turn off the ignition.

- Remove the side instrument panel cover on the driver side. Refer to => [ Side Instrument Panel Covers ] Side Instrument Panel Covers.

- Remove the instrument panel trim and the left and center instrument panel vents. Refer to => [ Instrument Cluster Trim, Left and Center Instrument Panel Vents ] Instrument Cluster Trim, Left and Center Instrument Panel Vents.

- Push the rotary light switch forward, turn it to the right until it is vertical, pull it out and disconnect the wiring harness.

- Remove the bolt - 2 - (1.5 Nm).

- Remove the screws - 4 - (1.5 Nm).

- Remove the left driver side instrument panel cover - 3 - from the instrument panel - 1 - and disconnect the connector from the headlamp range control adjuster (E102).






Installation

- Install in reverse order of removal.

• Check all the fasteners for damage and replace if necessary.