RNS 315+ (From 2012 =>)

RNS 315+

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)

• Replacement part number for Radio Navigation System (RNS) is located on a sticker on the radio housing.

• Always deactivate the electronic anti-theft protection when replacing the RNS. Refer to => [ Electronic Anti-Theft
Protection, Deactivating ] RNS 315+ (From 2012 =>). Give the customer the new radio code.

• If the radio code is not known, it can be retrieved via the known systems. The RNS serial number is needed. It is on a sticker on the side of the RNS housing. The serial number is also stamped into the side of the RNS itself.

• If an RNS from one vehicle is to be installed in another vehicle, make sure the RNS from both vehicles have the same replacement part number. Otherwise the navigation system will malfunction because rotation angle sensor setting in the RNS does not match the vehicle.

Removing


• Turn off the ignition and all electrical consumers.

• Remove the key.

- If there is a CD still in the player, remove it. Refer to the Owner's Manual.

Only Jetta MY 2012

- Remove the cover - 2 - from the instrument panel - 1 - using (3409).






All except Jetta MY 2012

- Remove the vents from center of the instrument panel.

- Remove the screws - arrows -.






- Remove the trim from center of the instrument panel.

All Vehicles

- Remove the screws - arrows -.






- Pull the radio/navigation display unit control module out of the installation slot just far enough until the connectors on the back are accessible.

- Squeeze the connector lock in direction of the - arrows -.






- Move the locking bracket in the direction of the - arrow - and remove the connector.






- Unlock the antenna connections - arrows - and disconnect the connectors.






- Unlock and disconnect the USB connection

Installing

Install in reverse order of removal. Note the following:

• Never push on the display or the buttons on the radio/navigation display unit control module when installing it. It will be damaged.

- Install the screws - arrows - in the radio/navigation display unit control module.






- Deactivate the electronic anti-theft protection. Refer to => [ Electronic Anti-Theft
System, Deactivating ] RNS 315+ (From 2012 =>).

- Check the coding for the radio/navigation display unit control module and code it again if necessary. Refer to => [ RNS 315+ Functions, Adapting ] RNS 315+ Functions, Adapting.

Torque specifications: 1.5 Nm