Washer Fluid Level Switch: Service and Repair

Windshield Washer Fluid Level Sensor (G33)


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removal

- Remove the front bumper cover.

- Disconnect the connector - 1 - from the windshield washer fluid level sensor - 2 -.






- Pull the windshield washer fluid level sensor - 2 - out of the rubber seal.

- Catch any draining washer fluid in a suitable container.

Installation

Installation is performed in the reverse order of removal. Note the following:

- Bleed the headlamp washer system. Refer to=> [ Headlamp Washer System, Bleeding ] Procedures.