Headlamp Spray Nozzle Holder

Headlamp Spray Nozzle Holder


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removal

- Remove the spray nozzle, with the cap - 1 -, from the bumper cover to the stop.






- Remove the cap - 1 - from the mountings - arrows - on the spray nozzle holder.

- Lift the retaining hook - arrow - slightly and remove the spray nozzle holder.






Installation

Use the catches on the spray nozzle holder to adjust how far the cap of the spray nozzle is pulled onto the bumper cover. The cap will not close if the spray nozzle bracket does not retract far enough. If the spray nozzle bracket moves with too much force, the cap and the bumper cover will get damaged.

- Push the spray nozzle holder into the lift cylinder until it locks in place.

- Install the cap on the spray nozzle holder and drain the lift cylinder.

- Check the cap for proper seating on the bumper cover.

- Adjust the cap if necessary by shifting the spray nozzle holder into a higher or lower catch on the lift cylinder.

- Bleed the headlamp washer systems. Refer to=> [ Headlamp Washer System, Bleeding ] Procedures.

- Check and adjust the headlamp washer system spray jets. Refer to=> [ Headlamp Washer System Spray Nozzles, Adjusting ] Adjustments.