Starter, Automatic Transmission

Starter, Automatic Transmission

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

• Torque Wrench (V.A.G 1332)


Always follow the instructions regarding disconnecting and connecting the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Removing

- Disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the engine cover upward - arrows -.






- Remove the air filter housing.

- Release and disconnect the connector (terminal 50) - 1 -.






- Remove the cap - 1 - from the solenoid switch in - direction of arrow -.






- Remove the nut - 1 - and disconnect the positive cable - 2 - from the solenoid switch.






- Remove the nut - 1 - from the bolt at the top of the starter.






- Remove the wire holder - 2 -.

- Remove the bolt at the top of the starter - arrow -.






- Remove the noise insulation.

- Disconnect the connectors - arrows -.






- Remove the nut - 1 - from the bolt at the bottom of the starter.






- Remove the wire holder - 2 -.

- Remove the bolt at the bottom of the starter - arrow -.






- Remove the starter from the vehicle.

Installing

Install in reverse order of removal. Note the following:

- Tighten the threaded connections to the tightening specifications. Refer to => [ Starter Overview ] Service and Repair.

- Connect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.