Ignition Switch

Ignition Switch


Always follow the instructions regarding disconnecting and connecting the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.


• Risk of airbag deployment!

• The airbag unit could deploy if mishandled.

• Read all the Safety Precautions before working on the airbags.

Removal

- Disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the steering wheel.

- Remove the steering column trim.

- Unlock the ignition switch with a small screwdriver - arrows -.






- Remove the ignition switch - 1 - from the steering lock housing.

Installation

- Install the ignition switch in the steering lock housing until it audibly latches.

- Insert ignition key into lock cylinder and turn into position "Drive".

Lock cylinder key positions





1. Position Off

2. Position Run

3. Position Start


- Connect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Further installation is done in reverse order of removal.

Check the Ignition Switch (D) => [ Ignition Switch, Checking, from 06.10 ] Ignition Switch, Checking, from 06.10.