Component Tests and General Diagnostics

Vehicle Electrical System Control Module (J519) Replace

The work procedure "replace the vehicle electrical system control module" contains the following scope of work:

• If a new vehicle electrical system control module is installed, it must be coded online.

• The factory mode in the vehicle electrical system control module is deactivated.

• All of the remote keys are programmed again.

The procedure to "replace the vehicle electrical system control module" can only be performed with the Vehicle diagnostic tester in the "guided fault finding" function.

Procedure

- Connect the -> Vehicle diagnostic tester.

- Select Guided Fault Finding.

- Use the GO TO button to select the "function/component selection" and the following menu options one after the other:

• Body

• Electrical Equipment

• 01 - On Board Diagnostic (OBD) capable systems

• 09 - vehicle electrical system control module

• Vehicle electrical system control module functions

• Replace the vehicle electrical system control module