Vehicle Electrical System Control Module (J519), from MY 10

Vehicle Electrical System Control Module (J519), from MY 10

The relay carrier is clipped to the bottom of the vehicle electrical system control module and can be removed.

If the vehicle electrical system control module is to be replaced, the work procedure to read out the codes stored in the module must always be performed. Refer to=> [ Vehicle Electrical System Control Module, Coding ] Vehicle Electrical System Control Module, Coding.


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removal

- Remove the relay panel from the vehicle electrical system control module. Refer to => [ Relay Carrier on Vehicle Electrical System Control Module (J519), from MY 10 ] Relay Carrier on Vehicle Electrical System Control Module (J519), from MY 10.

- Press the catches - arrows - and swivel the vehicle electrical system control module downward.






- Pull the vehicle electrical system control module downward and opposite the drive direction and remove it from the bracket.

- Disconnect the connectors.

Installation

Installation is performed in the reverse order of removal. Note the following:

- Insert the vehicle electrical system control module first with the back of the module into the bracket and push it up until it audibly latches.