Window Regulator Switch in Rear Door (E52)/(E54)

Window Regulator Switch in Rear Door (E52)/(E54)

Special tools, testers and auxiliary items required

• Trim Removal Wedge (VAS 3409)

The Left rear power window switch in left rear door (E52) and Right rear window switch in right rear door (E54) are removed and installed the same way so the procedure is only described for one of them.


• Turn off the ignition and all electrical consumers.

• Remove the key.

• When removing and installing components in visible area (switches, covers, trim, etc.), cover by taping the areas at which a prying tool ( (VAS 3409) , screwdriver) will be positioned using commercially available adhesive tape.

Removal

- Remove the upper section of the handle well from the pull handle.

- Release and disconnect the harness connector - arrow -.






- Open the four tabs - arrows - and remove the left rear power window switch in left rear door.






Installation

Install in reverse order of removal.

- Make sure the four tabs click into place when installing.