Steering Column Combination Switch (E595), Valeo

Steering Column Combination Switch (E595), Valeo


The removal and installation of individual steering column switch components must be done in a specified sequence. Refer to=> [ Steering Column Switch Components, Removal and Installation Sequence ] Steering Column Switch Components, Removal and Installation Sequence.


• Risk of airbag deployment!

• The airbag unit could deploy if mishandled.

• Follow the safety precautions when working on the airbag.


Always follow the instructions regarding disconnecting and connecting the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Removal

- Disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the steering wheel.

- Remove the steering column trim.

- Remove the steering column electronic systems control module (J527).






- Open the tabs - arrows - and remove the complete steering column combination switch (E595) from the steering column switch base carrier.

Installation

- Slide the steering column combination switch into the guides on the steering column switch base carrier until it latches secure.

- Connect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Further installation is in the reverse sequence to removal.