Crash Sensors, Doors, Front, Jetta from MY 05, Golf Wagon from MY 07 and Golf Wagon from MY 10

Crash Sensors, Doors, Front, Jetta from MY 05, Golf Wagon from MY 07 and Golf Wagon from MY 10

• The following describes removing and installing on the right side of the vehicle. Removal and installation for the left-hand side is performed in the same manner.

Removing


Read the General Safety Precautions for working with airbags, belt tensioners and battery cut-out units. Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units, General Safety Precautions ] Airbag, Belt Tensioner and Battery Cut-Out Units, General Safety Precautions.

All vehicles

- Disconnect the battery.

- Remove outer door plate.

- Disconnect the wiring harness - 1 - from the crash sensor - 3 -.

Vehicles with bolted crash sensors

- Remove two bolts - 2 - (2.5 Nm) and remove crash sensor - 3 -.






Vehicles with riveted crash sensors

- Drill out pop rivet - 1 -.

- Drill out pop rivet - 2 -.

- Disconnect the connector - 4 - from the crash sensor - 3 -.






Installing

Vehicles with bolted crash sensors

- Install in reverse order of removal.

Vehicles with riveted crash sensors

- Re-connect the connector - 4 - to the crash sensor.

- Attach the crash sensor to the subframe using a blind rivet - 2 -; use pop rivet pliers (VAS 5072).

- Attach the crash sensor to the subframe using a blind rivet - 1 - as described.






All vehicles

- Switch on ignition.


Make sure no one is in the vehicle.

- Connect vehicle battery.